mailgaq.blogg.se - Separation studio 4 print to regular printer

Choose high-quality print setting to print the marks as dark as possible.With the exception of FM (stochastic screening), all screens consist of dots arranged in a regular pattern or matrix. Ink smudges will interfere with scanning as will incompletely printed registration marks.

Check to be sure that the registration marks are printed clearly and fully.

When printing on dark colors such as these, place a square of white sticker paper in the registration mark areas before printing.

Dark papers, especially green or blue, do not provide enough contrast for the optical scanner to detect the registration marks.

You want there to be enough light for the scanner to see some contrast between the registration marks and the printed page but too much light can cause a reflection when using glossy media such as printable foil or shimmery cardstock.

Find the sweet spot when it comes to lighting.

For Type 1 registration marks, the square will be in the upper-left corner with brackets on the upper-right and lower-left corners.

Verify that the printed page is placed on the mat in the same orientation as it appears on the screen.

Check to see if there is anything blocking the eye of the optical scanner, such as a small scrap of vinyl.

Use the arrow keys in the software or on the machine to position the tool holder (Tool Holder 1 on machines with dual tool holders) over the square registration mark. When the “Registration Failed” message pops up, click on Manual.

If you have adjusted the registration marks, reset them to their defaults, adjust the design placement (if needed), and print the page again.(For tips on removing the background from an image, read this post.)

Delete any images located within the grey holding area on the screen. Check to be sure that no part of the printed design (even “white” areas that won’t be printed but are still detected as part of the design) falls within the cross-hatched areas or in the small indented area between the top registration marks.Make sure the correct type of registration marks has been selected for your machine.Verify that the page size in the page setup menu matches the printer setting for your media and that the correct mat (or “no mat”) setting and size has been selected.Make sure that your software and firmware are up to date.The cut images are misaligned, here are some troubleshooting tips to try: Software/Firmware

If the machine fails to recognize the registration marks or